RENMX | Forum

Corsair Obisidian Series 800D -$274.99
Alphacool NexXxoS Monsta Triple 120mm Radiator - 80mm Thick! $119.99
EK-Supremacy - Nickel € 65.95
1/2" UV Blue DreamFlex Tubing $29.95
EK-Coolant UV Blue € 6.98
EK-BAY SPIN Reservoir - Acetal CSQ € 54.95
EK-DCP 2.2 (12V DC Pump) - € 34.94

____________________________________________________________________________
Case -


____________________________________________________________________________Radiator

____________________________________________________________________________
Waterblock

____________________________________________________________________________
Tubing

____________________________________________________________________________
Coolant

____________________________________________________________________________
Reservior

____________________________________________________________________________
Pump

____________________________________________________________________________

Now i just need to find some UV Leds/Cathodes, and then i need some other stuff idk what there called. I have 3 months to decide. I'll get the total tommorow.

Would it be good if the case have round edges so when it flips upside down, it accidentally opens disk slot and the disk slot broke. Keep building anyway, it's going to be perfect.

freakboy31 wrote:Would it be good if the case have round edges so when it flips upside down, it accidentally opens disk slot and the disk slot broke. Keep building anyway, it's going to be perfect.

...

What?

Im so confused, freak!

I think what he's trying to say is that if the case had rounded edges, falling over wouldn't break the disk slot..?

I'd suggest you get the copper version of that cpu block, nickel coating does not add anything other than aesthetics and it has a tendency to flake off over time revealing the copper underneath (you pay more for something that will probably last less time than the copper version).

Also, where is your tube selection and barbs/compression fittings (you're going to need 8 for that setup)? It will be pretty useless without those!

To be honest I would strongly suggest you spend a bit more and invest in a Laing DDC pump (I have the DDC-1T+ Ultra which can push 600 liters per hour with a larger head of 4.7m over that EK pumps 2.2m) and a pump top to go with it so you can use it with 1/4" threaded barbs. if you wanted to upgrade the loop in the future that EK pump probably wouldn't cut it - IMO the pump is the most important part and you shouldn't skimp out on it.